 |
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
 |
KeepItPrinting.com
The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
yankeeboy
intern
Joined: 07 Jan 2010
Posts: 133
Location: syracuse,new york
|
 Posted: Fri Nov 12, 2010 1:24 pm Post subject: LEAKING TONER |
  |
|
| CAN ANYBODY GIVE SOME INSIGHT ON WHY TONER WOULD BE LEAKING IN OUR 8000 MACHINE AT THE CASE SUPPORT, I CAHANGED THE CASE SUPPORT IN THE MACHINE SAME RESULT. THIS PROBLEM IS IN TWO MACHINE SIDE BY SIDE AND STARTED ABOUT THE SAME TIME. SAME TONER FOR YEARS AND WE USE IT IN ALL FIVE OF OUR MACHINE. |
|
| |
|
|
|
|
|
|
|
|
MDRepro
medical school grad
Joined: 12 May 2006
Posts: 69
Location: Baltimore, MD
|
| Posted: Tue Mar 08, 2011 12:38 pm Post subject: |
|
|
| Are you still having this problem? I also began having that problem on a couple of our 8000's after using the same toner for years. I finally found where it was coming from...it's almost as if the toner sensor isn't reading the toner level in the hopper entrance(tried changing the sensor, but same problem) and it keeps forcing toner into the hopper entrance. I tricked the side door opened & watched & toner was actually shooting up in spurts like a mini geiser from the side of the toner hopper between the toner hopper cover & the toner hopper. I removed the cover & placed a narrow piece of black binding tape along the edge of the lid to create a better seal & that helped a lot. Not sure if this could be from a change in the toner consistency? The quality seemed the same though. |
|
| |
|
|
|
|
|
|
|
|
vi08
medical school grad
Joined: 16 Jul 2009
Posts: 73
Location: Des Moines, IA
|
| Posted: Wed Jun 01, 2011 6:23 pm Post subject: |
|
|
| is the square seal on the toner hopper to flat , not sealing properly |
|
| |
|
|
|
|
|
|
|
|
dlee
doctor
Joined: 07 Nov 2006
Posts: 1459
Location: E. Syracuse NY
|
| Posted: Thu Jun 02, 2011 9:20 am Post subject: |
|
|
| We ended up replacing the support case and the square seal 133. Seems to have fixed out issue. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
