Haggis
medical school grad
Joined: 29 Jun 2005
Posts: 62
Location: AZ
 |
 Posted: Thu Sep 22, 2005 3:31 pm Post subject: 2720 poor fusing on mylar |
  |
|
I just went and looked at a 2720 that runs bond great with no issues. But when they run mylar it does a few things that seem weird. with the fuser set at the temp that the manual says is fuses great on the first page then each subsaquent page the fusing in the middle gets worse and worse. Then we get spots of toner in the middle of the prints. If I turn the fuser up on the sides to 165 and the center to 0 the first mylar gets 'burnt' and all the pages after that the pages come out very light. If I turn the fuser temp down at all from there the pages look fine but the toner comes off the page really easy.
Any sugestions of where I should go next?
- Haggis |
|
