|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
Ace dreaming of medical school
Joined: 05 Feb 2012 Posts: 1 Location: Fort lauderdale, fl |
Posted: Sun Feb 05, 2012 7:37 pm Post subject: Oce 9800 over toning |
|
|
Hi Everyone,
Just found this forum this weekend. Great idea!
I am having a challenge with one of my machines. My Oce 9800 seems to be over toning and it causes the build roller and pressure cleaner roller to stick together. I replaced the rollers but had the same result. All rollers were seated correctly, good bearings, good air pressure from the compressor. I ended up unplugging the machine for the night and the next day repeated the process and it worked fine... Until the next day when we turned the machine on again and the problem returned. I have since tried changing the air control unit but to no avail.
Does anyone have any suggestions that I might try?
Thanks in advance for any assistance.
Regards,
Ron _________________ Ace |
|
|
|
|
|
|
|
|
|
|
mark in vegas doctor
Joined: 20 Oct 2010 Posts: 1852 Location: Las Vegas, NV |
Posted: Mon Feb 06, 2012 12:29 pm Post subject: |
|
|
You will need the documentation to go forward. The exposure has a great effect on the "overtoning" you see. Are you using OEM toner? The rolls are sticking together because they're overloaded, not due to a pnuematic issue. Is the drum over 1mil? Pin arrays? The internal lens on the PHD can be crapped up causing problems...... _________________ Regards,
Mark
RVN 68-69
It's so nice to be insane
No one asks you to explain |
|
|
|
|
|
|
|
|
|
|
printertechrep medical school senior
Joined: 12 May 2011 Posts: 31
|
Posted: Tue Feb 07, 2012 8:09 pm Post subject: |
|
|
How quickly did the cleaning rollers fill up? If in a very short time there is a problem with the prinhead not turning on and therefore printing solid black which gets transfered to the fuser roller, pressure roller then cleaning rollers. Could be connections on the printhead or small ribbon cable loose or the printhead data receiver (board on back of printhead). |
|
|
|
|
|
|
|
|
|
|
mark in vegas doctor
Joined: 20 Oct 2010 Posts: 1852 Location: Las Vegas, NV |
Posted: Tue Feb 07, 2012 8:44 pm Post subject: |
|
|
Only because I forgot once, the torides are installed in the cleaning rolls?? Also make sure the bearings are seated completely in the cutouts. _________________ Regards,
Mark
RVN 68-69
It's so nice to be insane
No one asks you to explain |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|