|
|
|
|
|
|
|
|
|
|
Jammin intern
Joined: 04 Sep 2007 Posts: 121 Location: Colorado |
Posted: Wed Aug 10, 2011 7:36 pm Post subject: Designjet 800 After belt replacement |
|
|
Darn never had this one before looking for some guidance from the KIP pros.LOL
After replacing the belt, i power up machine and hear the service station moan and get a 21:10 error. I replaced the Service station on this machine 6 months ago. After lokking and looking cannot find anything i did wrong. went as far as driving back to the shop for a new SS and installed same problem.
Any ideas here?
Firmware is at A.02.05 so i believe i am good there.
Thanks |
|
|
|
|
|
|
|
|
|
|
Chazbo doctor
Joined: 05 Jul 2005 Posts: 377
|
Posted: Thu Aug 11, 2011 9:41 am Post subject: |
|
|
I have had this happen
there may be a loose connection on the interconnect board (the small PC board the service station plugs into) re-seat all of the connectors on the board _________________ Ride To Live |
|
|
|
|
|
|
|
|
|
|
caltech doctor
Joined: 24 Feb 2006 Posts: 262 Location: Northern California |
Posted: Fri Aug 12, 2011 2:10 am Post subject: |
|
|
This error can also be caused by the ribbon cable that plugs into the interconnect board. Check it where it folds over itself and take out the kink in the fold. |
|
|
|
|
|
|
|
|
|
|
Jammin intern
Joined: 04 Sep 2007 Posts: 121 Location: Colorado |
Posted: Thu Aug 18, 2011 5:16 pm Post subject: |
|
|
Thank you all very much Fixed it all up. It was the ribbon cable was pinched in the service station holder. My bad..... |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|