 |
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
 |
KeepItPrinting.com
The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
PPCPete
resident
Joined: 20 Feb 2005
Posts: 196
Location: Wisconsin
|
 Posted: Wed Oct 05, 2005 3:49 pm Post subject: 1800 J-3 HELP!!!!! |
  |
|
I have an 1800 I am refurbing for a future sale. It worked fine when it came from it's previous account. I am experiencing J-3 only when I run more then 2 copies. If I run 1 it is fine, but if 2 or more are ran then every time the origanal starts it's return for the next scan it stops and gives a J-3. I have reason to believe it is an original feeding issue unless proven wrong. I have tried both reverse clutches which were no help. I have time to waste on this refurb. But it is baffling me, any help would be appreciated. I have tried new T&S wires new ph9 sensor(ph7 was working in diagnostic) and one set of the feed rollers inside printer was replace due to rubber spinning on shaft(rest were fine)
_________________
PPCPete |
|
| |
|
|
|
|
|
|
|
|
Cabok
intern
Joined: 13 Dec 2004
Posts: 117
Location: Montreal
|
| Posted: Fri Dec 16, 2005 5:55 pm Post subject: |
|
|
I had a 1880 with a bad return motor gearbox. Listen to the motor when you paper is coming back, is it struggling ? My machine had seen a lot of paper, and that gearbox needed a good lube. Works great now.
I never had to replace a clutch on the top section of an 1880. I don't think it's (or was) the problem. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
