 |
|
|
|
|
|
|
|
|
|
TXReproShop
doctor
Joined: 04 Apr 2005
Posts: 300
|
 Posted: Tue May 22, 2007 11:20 pm Post subject: Right Side Horizontal Line |
  |
|
It is at about 250mm down from the leading edge on the right side (as you face the machine). It goes to the other side of the print and fades out. Does not repeat on the same print, but will show again on the next one in the exact position.
Any ideas - I have done everything I can think of as far as wires, etc. |
|
| |
|
|
|
|
|
|
|
|
9lives
intern
Joined: 05 Jun 2006
Posts: 107
|
| Posted: Wed May 23, 2007 9:36 am Post subject: |
|
|
Could it be the leading edge needs to be adjusted? Sounds like it may be repeating the border from the lead edge of the print.
_________________
There is nothing more freeing than leaving a "perfectly good airplane" at 10,000 ft, landing safely, and packing up to go do it again! |
|
| |
|
|
|
|
|
|
|
|
TXReproShop
doctor
Joined: 04 Apr 2005
Posts: 300
|
| Posted: Wed May 23, 2007 12:25 pm Post subject: |
|
|
| This is not a "repeat" or reprint of a border. This line is about the width of sewing thread and runs for about 3 inches to the left side. |
|
| |
|
|
|
|
|
|
|
|
peter_kelowna
medical school grad
Joined: 28 Nov 2006
Posts: 78
|
| Posted: Mon Jul 09, 2007 3:47 pm Post subject: new ideas |
|
|
| Hi there, If you are still having this problem it may be worth the time to look at the cutter and if it stalling the paper. Could also be fuser motor speed timing. |
|
| |
|
|
|
|
|
|
|
|
Charlie Brown
doctor
Joined: 09 Aug 2005
Posts: 434
Location: Nashville Tennessee
|
| Posted: Mon Jul 09, 2007 10:13 pm Post subject: Line |
|
|
I had one something like this found it was a bad spot on mag roller after I reclean it the problem went away. this was on a 6000 but it could be the same. 
Grandkids make the day |
|
| |
|
|
|
|
|
|
|
|
TXReproShop
doctor
Joined: 04 Apr 2005
Posts: 300
|
| Posted: Tue Jul 10, 2007 7:41 pm Post subject: |
|
|
| This ended up being a transfer issue. "Painted" the inside of the blocks with fingernail polish and it has been fine. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
