 |
|
|
|
|
|
|
|
|
|
Bill
intern
Joined: 14 Dec 2004
Posts: 104
Location: Canada
|
 Posted: Tue Apr 19, 2005 12:38 pm Post subject: KIP 3400 ERROR ???? |
  |
|
Just replaced the photoreceptor & cleaning blade assy. Completely
vacumed out developer and started with all fresh toner. Re-asembeled
machine and everything was working well with exception of a small
black smudge on the left side, so i hauled it apart and manually rotated
the drum motor to see if any marks on the drum nothing so i put Kynar
back on the drum and buttoned it back up again. Now when it becomes
ready it flashes up "E0-12" i've recleaned the cln blade and the hopper assy and checked for free movement and it seems fine.
Any Ideas 
Thanks in advance
Bill |
|
| |
|
|
|
|
|
|
|
|
rico
medical school grad
Joined: 19 Apr 2005
Posts: 60
|
| Posted: Fri Apr 29, 2005 1:07 pm Post subject: |
|
|
| process motor error. |
|
| |
|
|
|
|
|
|
|
|
Bill
intern
Joined: 14 Dec 2004
Posts: 104
Location: Canada
|
| Posted: Tue May 03, 2005 9:29 am Post subject: 3400 error |
|
|
Went to diag and the motor runs forward & reverse no problems
so i tried a new motor got same result ? E012
Is there something else in the loop that can trigger this
code ? in the service check list for this code i don't get
a drop in voltage to 0 volts DC when pressing the start key.
I looking towards the DC controller but i want to make sure first
this machine is old and we want to keep cost down and as you know
that board is $$$$$$$$
Any ideas ??
Thanks Bill |
|
| |
|
|
|
|
|
|
|
|
rico
medical school grad
Joined: 19 Apr 2005
Posts: 60
|
| Posted: Tue May 03, 2005 2:15 pm Post subject: |
|
|
| if you dont get a drop in voltage from 5 to 0v it probably is the pcb. check all wires first... j202-23 j200-5 |
|
| |
|
|
|
|
|
|
|
|
Bill
intern
Joined: 14 Dec 2004
Posts: 104
Location: Canada
|
| Posted: Sun May 15, 2005 10:16 am Post subject: |
|
|
Rico,
j202-23 j200-5 what do you mean? are you looking for
voltage? please elaborate.
Thanks BP |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
