 |
|
|
|
|
|
|
|
|
|
david burford
dreaming of medical school
Joined: 26 Feb 2007
Posts: 4
Location: lubbock tx
|
 Posted: Tue Feb 27, 2007 1:14 pm Post subject: cutting 1" to long |
  |
|
| it all started when the pdisk was loose and wiped out hp sensor. I replaced the sensor and board and tightened everyrthing up and the cutter started cutting everysheet 1" to long out of all 4 decks. I have gone with kip diagnostic and changed all the settings down to 1 and i got the length so now it is still 1/4 " long any suggestions? THANX |
|
| |
|
|
|
|
|
|
|
|
CHILLIN
doctor
Joined: 05 Oct 2006
Posts: 950
|
| Posted: Tue Feb 27, 2007 6:01 pm Post subject: |
|
|
| Did you by chance put the pulse disc on the same way you took it off? If it is not on the same way it came off this will cause the sheets to cut too long. |
|
| |
|
|
|
|
|
|
|
|
david burford
dreaming of medical school
Joined: 26 Feb 2007
Posts: 4
Location: lubbock tx
|
| Posted: Thu Mar 01, 2007 6:53 pm Post subject: thanx chillin |
|
|
| I turned the pdisk over and that took care of my problem thanx again for your quick responce |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
