 |
|
|
|
|
|
|
|
|
|
damstr8t
Guest
|
 Posted: Wed Jun 07, 2006 3:41 pm Post subject: kip 6000 jaming only 1\2 size prints!!!! |
  |
|
 HELP!!!! WE ARE HAVING INTERMITENT PAPER JAMS ON HALF SIZE PRINTS 11" AND 18" PAPER ONLY USUALLY 11" TO 12" LONG PRINTS. WE HAVE REPLACED ALL FEED CLUTCHES, CHECKED SENSORS, AND REPLACED TRANSFER AND SEPARATION WIRES. THE JAMS USUALLY HAPPEN WHEN MAKING MULTIPUL PLOTS. THE PAPER JAMS AT THE FUSER ENTRANCE WITH THE NEXT SHEET OF PAPER STARTING TO FEED UNDER IT. DURING A GOOD RUN THE MACHINE ALSO INTERMITENTLY WILL HAVE A SMEARED AREA AT THE TRAIL EDGE THAT SEEMS TO BE CAUSED BY THE PAPER STICKING OR BINDING BUT IT DOES NOT JAM! THE MACHINE USUALLY SHOWS ERROR CODE J13 WHEN THE PROBLEM OCCURS. THANKS FOR ANY HELP!!!!!!!! |
|
| |
|
|
|
|
|
|
|
|
rico
medical school grad
Joined: 19 Apr 2005
Posts: 60
|
| Posted: Wed Jun 07, 2006 9:05 pm Post subject: |
|
|
| maybe fuser speed |
|
| |
|
|
|
|
|
|
|
|
Charlie Brown
doctor
Joined: 09 Aug 2005
Posts: 434
Location: Nashville Tennessee
|
| Posted: Wed Jun 07, 2006 9:07 pm Post subject: 1/2 prints |
|
|
| Have you try coving some of the sides vents beside the belts so you will get more suction on the center. |
|
| |
|
|
|
|
|
|
|
|
guest1234
Guest
|
| Posted: Wed Jun 07, 2006 9:23 pm Post subject: 1/2 prints |
|
|
| Try replacing the transfer area sensor actuator. I have seen when the spring on that actuator is too strong the paper cant hold it down causing the same issue. |
|
| |
|
|
|
|
|
|
|
|
KIP Dude
resident
Joined: 14 Feb 2006
Posts: 164
Location: Outside USA
|
| Posted: Thu Jun 08, 2006 3:09 am Post subject: |
|
|
In the unattend.ini you can set the minimum cut length to 12". The distance between the sensors is not enough to allow paper under 12" to successfully go through. Change it and you'll be fine
_________________
Everytime something is made idiot proof... the world creates a better idiot! |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
