KeepItPrinting.com

Thanks, I will let you know what we find.

Hello Mark,

If you want two machines we can cut you a better deal. We are asking $7,000 for each of the three systems. Also, if you could provide a zip code, we can get a shipping quote. Normally, ...

I am blushing! Thanks for the vote of confidence!!

We have the Dell controllers available. Just shoot me a note.
Carl [email protected]

Out of curiosity, how much did you pay for it? For future reference, I charge $800 to rebuild them. If you have the bad unit, drop me a note, I will buy it and pay for shipping.

Carl

I don't know of any way to get just the fuser control board. However, I offer rebuilt AC Modules and they come with a six month warrantee. Drop me a note at [email protected]

Hey Chasbo,

Thanks for the info!

Nice choice of rides by the way! I have a '92 Sporty.
Keep the rubber side down!

Carl

Hey Chasbo,

Thanks for the info. Do you happen to have the KIP part number for the kit? Is it true that the kit comes with instructions about how to make the change over? Also, what was the cost fo ...

KIPDOCTOR,

So if you install a 5000 developer housing in a 6000, what changes would need to be made to the bias voltages? With those changes made, would the housing then work? We understand that th ...

Spoke too soon! Same problem is back with a vengeance. Any thoughts would be much appreciated!

Well, the machine is working now. I tested the 24 volt power to both the transfer and D/T power supplies as you suggested. I found that the voltage would drop when the second print was being processed ...

We have an 8000 that is doing the exact same thing as actrepro described. Both 36V powersupplies look good. Actrepro, did you determine what the cause of your problem was?

I am looking for new or used 7xx service stations. [email protected]

Thanks,

Carl

The gears have been checked, and replaced as needed. The issue seems to be that the developer housing is lifting up under the torque of drive. There is enough play in the capture bracket that otherwis ...

When the machine is printing, the developer housing jumps as it is running. There is no apparent binding in the housing, but presumably there is excessive drag in the housing. Any thoughts?