Author |
Message |
Topic: Wire cleaning pad "hanging" over center of print w |
DHolland
Replies: 10
Views: 10238
|
Forum: KIP 8000 Discussions
Posted: Wed Jan 05, 2005 12:30 pm Subject:
Wire cleaning pad "hanging" over center of print w |
Thanks for the quick answers and advice. I took the assembly apart and, while there was some toner build-up around the plastic end pieces, it wasn't much. I cleaned it all, lubed it all and so far, ... |
Topic: Wire cleaning pad "hanging" over center of print w |
DHolland
Replies: 10
Views: 10238
|
Forum: KIP 8000 Discussions
Posted: Mon Jan 03, 2005 11:35 am Subject:
Wire cleaning pad "hanging" over center of print w |
The main charge wire cleaning pad stops long before returning to its home position, leaving a 3/4" solid black stripe leading edge to trailing edge. Nothing is binding or hanging and a KIP tech from ... |
Topic: 2050 scanner and 7000 |
DHolland
Replies: 5
Views: 5836
|
Forum: Kip 7000 discussions
Posted: Wed Dec 15, 2004 11:45 am Subject:
2050 scanner and 7000 |
Thanks for the prompt help. Still working on fine calibration, but the culprit was BUD 24, direct print. Duh, I can't have direct print between those two! I need a donut.
Thanks again! |
Topic: 2050 scanner and 7000 |
DHolland
Replies: 5
Views: 5836
|
Forum: Kip 7000 discussions
Posted: Tue Dec 14, 2004 12:31 pm Subject:
2050 scanner and 7000 |
Thanks!,
I'll dig in and see. We had this 2050 connected to a 2000 and my assumption was I could leave the settings alone. I'll keep you posted. |
Topic: 2050 scanner and 7000 |
DHolland
Replies: 5
Views: 5836
|
Forum: Kip 7000 discussions
Posted: Tue Dec 14, 2004 12:16 pm Subject:
2050 scanner and 7000 |
Just installed this setup and have current firmware for both. In synchro copy mode, copies are cut off 8" at the trailing edge. In set mode and for scans to file, the scanner works fine. I've insta ... |
Topic: Intro and thanks |
DHolland
Replies: 1
Views: 7208
|
Forum: Basic info about these forums.
Posted: Tue Dec 14, 2004 11:43 am Subject:
Intro and thanks |
I'm a KIP "tech" (still learning on the job) in TX. Been to 2000, 2000 scanner, and 8000 training. Thanks for putting this new site together! I'll post my current question in the 7000 section. |